![]() If the status does not switch to COMPL (complete), restart the engine, make sure that the preconditions have been met, and then perform the Monitor Conditions again. Check the Readiness Monitor status displayed on the tester or scan tool. Connect a hand-held tester or OBD II scan tool to the DLC3.Ĥ. A trick is to turn off the a/c and get the catalyst hot, cruise at 70 for a couple of mins, then pull over and come to a complete stop for at least a minute. If the engine is started, the step described above must be repeated.ġ.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |